We widely apply lininkost in the design of the walls to create the effect of decorative modeling. This is environmentally friendly material, made on the basis of sawdust, wax, chalk, oil of linen and other natural materials. Lincruste has the property of stable holding a relief pattern. This is a strong material that can hide the defective irregularities of the surface. It has high moisture resistance and heat resistance, but requires a rather complicated factory technology, has a high price and unstable to temperatures below fifteen degrees above zero mark. By the way, the site promotion service is very popular now by many companies use it.
Preparatory work:
The preparation of walls is carried out by removing the old decoration, small particles of construction dust are removed, platbands and skirting boards are removed.
In order to avoid the appearance of a fungus or mold, the walls are covered with an antiseptic, and allow it to dry.
The coating of the starting putty is aligned, it is also closed with cracks on the walls. After drying, clean the roughness, rinse off dust and again covered with a layer of antiseptic. For drying you need to withstand three days.
We complete the preparation with a layer of finish putty, after drying it, we make grinding and cleansing and antiseptic processing, and leave it for three court for drying the primer.
The main technological process:
Lincrust is produced in rolls, so first of all it needs to be cut into the necessary sheets, saving the selection of a pattern.
Previously heating the water to a temperature of 60 degrees, the rolled parts of the linkerist are immersed in it for 10 minutes.
After folding wet sheets in a pile and remove excess water. In this position, the lincuruste should remain about 10 hours. During this time, the material will soften and sit down. Then the cuts are equal. By cutting irregularities with a clerical knife. If your use is a fabric base in your use, then you do not need to soak it.
For attaching a linkerist to the wall, it is more practical to use a perchlorvinyl glue.
The wrong side of the material is covered with glue, it is doubled, and is left for 10 minutes. Then apply a layer of glue to the wall and glue lininkrast. Subsequent sheets are laid in one to one to one. It so happens that in the corners of the room the sheets are overlapped, then a rake is attached to it for two days to fix the seam to it for two days.
During work with Lincrust, you need to avoid drafts and sharp changes in temperature.
It is necessary to allow the materials to dry and shrugged for a week.
The final stage is the coloring of the coating, having previously nailed the baseboard back.